Scotts Damper Arm Puller Tool SALE A new gasket and 'O'

A new gasket and 'O' Ring is supplied with each unit and should be used even if the original looks serviceable

risers are optional

No alteration to the frame or plastics required

This SUB Mount allows you to run the bars in two positions: 10mm or 20mm in front of the steering stem

these bolt right over your OEM engine side cases

Scotts Damper Arm Puller Tool SALE A new gasket and 'O'The Link Arm Puller, also known as Arm Remover tool, allows you to remove the link arm without damage to the seal area on the bottom of the stabilizer. This puller is also essential for those of you who plan to service your stabilizer yourselves. Note: If the damper arm nut has been installed with permanent thread lock compound (usually red), it may require some heat to loosen the compound. Apply thread lock when reinstalling the nut. Do not over